Drills and Drill Bits
Grainger Drill Mill 3/4 Carbide Bright
The Micro 100 16T604 is a carbide drill mill with a 1/4" shank diameter and a 1/2" cutting diameter. It has a TiAlN coating and can be run at speeds up to 325 SFM. The drill mill has a 135 degree split point tip angle and is made of micrograin carbide for strength and heat resistance. It can drill, chamfer, face mill and slot in steel, cast iron, aluminum and other non-ferrous metals. The 16T604 is manufactured in the USA by Micro 100 Tool Corp.
Grainger Sq. End Mill Single End Carb 1/4
The Grainger Approved Square End Mill Single End is a high-speed steel end mill with a square end for milling slots, keyways, and pockets. It has a 1/2" shank diameter, a 1-1/2" overall length, and a 1/2" cutter diameter. The end mill has 4 flutes and a right-hand spiral. It is uncoated and made in the USA. The end mill can be used on steel, stainless steel, cast iron, aluminum, copper, brass, bronze, plastic, and fiberglass. It has an operating speed of 55-575 SFM and feed rates from 0.002-0.012 IPR.
Grainger Sq. End Mill Single End Carb 0.0150
The Grainger 14K487 is a 14 gauge, type 1 extension cord that is 50 feet long. It has a yellow jacket and is designed for indoor and outdoor use. The 3-wire grounded cord has a molded plug on one end and receptacle on the other end. It is UL listed and CSA certified. The 14 gauge wire allows it to handle up to 15 amps and 1875 watts. This commercial-grade extension cord can be used for power tools, appliances, lighting, and more.
Grainger Ball End Mill Single End 3.00mm Carbide
The Grainger 14K735 is a 14 gauge, type 1 solid copper building wire with THHN insulation. It is rated up to 90°C dry and 75°C wet locations. This wire comes in 500 foot spools and is UL and CSA listed. The 14K735 building wire is designed for use in conduit and general purpose wiring applications.
